







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Richmond Heights, FL: What It Costs and How Long It Takes
Asphalt Driveways & Resurfacing in Richmond Heights, FL typically runs $3,500 to $9,000 for a full new asphalt drive, and $250 to $700 for a sealcoat refresh. A standard driveway goes down in two to three days: one day to demo and grade, one day to pour and compact the base, one day to lay the asphalt. Call (844) 834-8961 and we’ll walk your property, measure the square footage, and hand you a written line-item quote.
Richmond Heights gets hammered by May through November storm season, and a driveway that’s already cracking, rutting, or pooling water is the first thing to fail when the rain comes sideways. The good news is that asphalt is the one surface here that can be torn out and rebuilt without touching the house.
How We Build an Asphalt Drive in Richmond Heights, Step by Step

Every job follows the same sequence. Here’s exactly what happens, when, and what you decide at each stage.
Stage 1: Site walk and subsurface check (day 1, 1 to 2 hours)
We come out, measure the drive, and probe what’s under the existing surface. If there’s old concrete, crushed shell, or a failed asphalt layer beneath, that changes the base preparation and the price. You decide nothing yet. This is information gathering, and it’s where most bids go wrong because the contractor never looked under the surface.
Stage 2: Demo and grading (day 1, 3 to 6 hours)
We break out the old surface, haul it off, and regrade the sub-base so water drains away from the house and toward the street or a swale. This is the stage where Richmond Heights’ flat, low-lying lots bite you. If your yard holds water after a storm, we build the crown and slope into the base now, not later. You approve the finished grade before we move on.
Stage 3: Base installation and compaction (day 2, 4 to 6 hours)
We lay crushed limestone base in lifts, wet it down, and compact each lift with a plate compactor. A driveway base is only as good as the compaction. This is the step cheap crews skip, and it’s the reason drives crack within two years. You’ll want to be home to see the base depth before the asphalt goes down. It’s your last chance to verify the thickness you’re paying for.
Stage 4: Asphalt laydown (day 2 or 3, 3 to 5 hours)
Hot-mix asphalt arrives and gets spread with a paver, then rolled with a 3- to 5-ton roller while it’s still hot. A standard residential drive gets 2 inches of compacted asphalt over 4 to 6 inches of base. The surface needs 24 to 48 hours of cure time before you park on it, and 30 days before it can be sealcoated, which matters if you’re planning a reseal.
Stage 5: Cleanup and final walkthrough (day 3, under an hour)
We sweep, haul off excess material, and walk the finished surface with you edge to edge. Any irregularity, low spot, or drainage concern gets flagged and addressed right there. That’s also when we hand you the care sheet. No vehicles for 48 hours, no heavy loads for a week, and no washing the surface for the first month.
The whole sequence fits into a long weekend for a typical Richmond Heights residential drive. Larger drives, or jobs where we’re relocating a swale or installing drainage grates, run a day longer. If your driveway project is part of a full Driveway & Pavers in Richmond Heights scope, we scope both at once so grading and drainage are planned together rather than twice.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between on an Asphalt Resurface
Asphalt isn’t one product. The grade, the base, and the finish all get picked before we start, and the trade-offs are real.
- Full-depth replacement vs. overlay. A full rebuild means tearing out the old surface down to the sub-base. It’s the more expensive option, but it’s the only one that fixes a base that’s already failing. A 2-inch overlay goes on top of sound asphalt and costs considerably less. The catch: it only buys you time, and it adds 2 inches of height at the garage apron that has to be feathered.
- Hot-mix vs. cold-patch. Hot-mix asphalt is the real product, laid hot at the plant and finished by machine. Cold-patch is a bagged product for filling potholes, not for a full drive. Any crew offering to lay a whole driveway with cold-patch is cutting a corner you’ll pay for within a season.
- Base depth and material. A 4-inch base is fine for a passenger car drive. A 6- to 8-inch base is what you want for an RV pad, a boat trailer, or a heavy truck. The deeper base adds surface area and hauling cost, which pushes the number up.
- Sealcoat timing and type. A new asphalt drive needs to cure 30 days before its first sealcoat. After that, seal every 2 to 3 years. Sealcoat keeps the sun from drying out the binder and keeps water out of hairline cracks. Skip it and a $6,000 drive starts wearing out years early.
- Edge restraint and drainage. Asphalt edges need constraint or they ravel. A concrete curb, landscape edging, or a compacted shoulder all hold the edge. Drainage grates or channel drains at the garage apron add cost but prevent the flooding that’s so common on these flat lots.
What Asphalt Driveways & Resurfacing Costs in Richmond Heights, FL

Paving a new asphalt driveway in Richmond Heights runs $3,500 to $9,000. A driveway replacement, where we tear out the existing surface and rebuild, runs $5,000 to $14,000. A sealcoat to protect an existing drive runs $250 to $700. Those numbers are the real range we quote here, not a teaser.
What pushes a job to the low or high end of that range:
- Square footage. A single-car drive under 400 square feet sits at the bottom of the range. A wide three-car drive with a turnaround can top the range on its own.
- Existing surface condition. A failed surface that has to be broken out and hauled increases demo and disposal. A sound surface that only needs an overlay reduces it.
- Drainage work. Adding a channel drain, relocating a swale, or correcting slope adds cost, but it’s the difference between a drive that sheds water and one that becomes a pond.
- Base depth and material. Deeper base and heavier compaction for an RV or boat pad adds to the job.
- Permits and access. If the drive connects to a county right-of-way, there may be a right-of-way permit and inspection involved. Those get pulled and inspected as part of the job.
Every quote we write is line-itemed. Base depth and square footage are spelled out, so you can see what you’re paying for. The number you see is the number you pay, and the work is covered by the 730-Day Done Right Promise. If a driveway settles or cracks prematurely, we come back and make it right.
See the difference
Before
After
Before
After
Before
AfterWhat Richmond Heights Homes Specifically Do to This Job
Richmond Heights is a built-out, mid-century South Miami-Dade community, ZIP code 33176, and almost all of the housing stock dates to the 1950s through the 1970s. The typical home is a CBS (concrete block and stucco) ranch on a modest lot. That means most of our asphalt work here is replacement, not new construction. The original drive may have been poured or laid over 50 years ago, so it’s often failed: alligator cracking, rutted edges, a sunken apron at the garage. We see original drives along the streets off Southwest 152nd Street and throughout the older blocks near Richmond Heights that have never been redone, and the storm season from May through November is what finished them off.
Because the area is built out, driveway work here almost always collides with something else: a re-roof, an impact-window retrofit, a re-pipe, or a hurricane-hardening upgrade. We routinely see drives torn up for utility trenching or equipment staging, then patched piecemeal and left cracked for years. If your drive needs to be re-done after another job comes through, that’s a conversation worth having up front.
Two more local realities. First, the flat lots here drain poorly, so every asphalt job we do in Richmond Heights gets a deliberate crown and slope away from the house, with a channel drain added when a swale isn’t enough. Second, any change to the right-of-way or the driveway apron has to meet Miami-Dade’s permitting and inspection rules. Whether a permit applies depends on scope, and the county’s wind-load and product-approval standards shape what happens near the structure. We handle permits and inspections as part of the job, and you don’t chase them. Homeowners often pair this with Chain Link Fence in Richmond Heights to define the property line before paving, or with ADU Site Prep & Utilities in Richmond Heights if an addition is on the same lot. If your project touches grading or drainage across the property, our Driveway & Pavers service covers that side of the work, and you can see the wider Richmond Heights service area for how we cover the neighborhood.
Serving Richmond Heights, FL – Our Local Coverage Area
We serve Richmond Heights and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Asphalt Driveways & Resurfacing in Richmond Heights

A typical residential asphalt driveway takes two to three working days from demo to final walkthrough. Add 24 to 48 hours of cure time before you park on it and 30 days before it can be sealcoated. Larger drives or jobs with drainage work add a day. Call (844) 834-8961 for a timeline for your specific lot, and the estimate is free.
It depends on the scope. A driveway replaced within the existing footprint usually needs no county permit, but any work that touches the right-of-way, the street apron, or drainage tied to the public system does. When a permit applies, we pull it and pass the inspection. Call (844) 834-8961 and we’ll tell you straight whether your job needs one.
Yes, if the base underneath is still sound. An overlay adds a 2-inch layer of new asphalt on top of existing asphalt that has no major base failure, and it’s the less expensive route. If the old drive is alligator-cracked or settling, an overlay will crack through within a season, and a full rebuild is the honest answer. Call (844) 834-8961 for a look, and the estimate is free.
New asphalt paving runs $3,500 to $9,000, a full replacement with tear-out runs $5,000 to $14,000, and a sealcoat runs $250 to $700. The number depends on square footage, base depth, existing condition, and drainage. Call (844) 834-8961 for an exact line-item quote.
Every asphalt job we do in Richmond Heights is covered by the 730-Day Done Right Promise: if it isn’t done right, we make it right, for two full years from completion. That covers workmanship, not normal wear or damage from vehicles you didn’t tell us about. Call (844) 834-8961 to go over the details before you commit.
Get a Free Estimate for Asphalt Driveways & Resurfacing in Richmond Heights
Call (844) 834-8961 to schedule a free on-site estimate for Asphalt Driveways & Resurfacing in Richmond Heights. A real person answers, any hour of the day. We’ll walk the property, measure the drive, check the base, and hand you a written line-item quote with upfront pricing and no surprises. Financing is available at 0% for 18 months, and projects over $10,000 get $1,000 off. Estimates are free, and there’s no pressure to decide on the spot.
Written by the team at Groundwork Construction Co.












