







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in Sunset, FL
Concrete driveways and concrete work in Sunset, FL typically run $4,500 – $12,000 for a full driveway pour, with most jobs taking 3 – 5 working days from demo to the first drive-on. That includes the base prep, forms, the pour, the control joints and the cure window. A replacement over an old slab lands around $5,000 – $14,000 because there’s tear-out and hauling on top of the new work. Call (844) 834-8961 and we’ll walk your property, measure the run, and put real numbers in writing.
Most of what people here want is a slab that takes the summer rain, doesn’t pond at the garage door, and holds up through hurricane season. We do that. Here’s how we get there.
How we pour a driveway in Sunset, from demo to drive-on

The sequence barely changes from job to job, but the timing depends on how much old concrete has to come out and whether the subgrade is wet when we start. What you can count on is roughly 3 – 5 working days of crew time, plus a cure period before you park on it.
Stage 1: Layout and utility check (Day 1)
We stake the runs and confirm the slope before anything gets broken. In Sunset this matters because so many lots sit low relative to the street, and a slab that’s not pitched right pushes water under the garage door instead of out to the swale. We also call in the utility locates. You’ll want to decide at this point where the slab ends and whether you’re adding a pad or a walk alongside it.
Stage 2: Demolition and hauling (Day 1 – 2)
Old concrete comes out with a breaker and gets loaded out same day. A standard two-car driveway generates several tons of rubble, so hauling is a real line item, not an afterthought. If you’re keeping a portion of the existing slab, we cut a clean saw joint and tie the new pour into it with dowels.
Stage 3: Subgrade, base and forms (Day 2 – 3)
We strip the topsoil and any soft material, then compact the subgrade and set a compacted base. Forms go up on the finished grade, and reinforcement gets placed. This is the stage where the job is actually won or lost, and it’s the stage most cheap quotes skip. You’ll want to be available to confirm final grade height against the garage apron.
Stage 4: The pour and finish (Day 3 – 4)
Concrete arrives, gets spread, screeded and finished to the texture you picked. Control joints get cut at the spacing the slab needs so cracks land where they’re supposed to. You’ll want to choose broom, exposed aggregate or a stamped pattern before this day, because finish is not something you change after the truck is on site.
Stage 5: Cure and striping (Day 4 – 5 plus cure)
Forms come off within a day, and the slab needs to cure before it sees a vehicle. Keep foot traffic off for a minimum of 24 hours and cars off for several days; full cure takes weeks. If you’re sealing it, that happens after cure, not day one.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll actually choose between
Concrete driveway work in Sunset comes down to a handful of decisions. Here’s the honest trade-off on each.
- Standard 4-inch slab vs. 5 – 6-inch reinforced slab: A 4-inch pour is fine for foot traffic and light cars. If you park a truck, a boat trailer or an RV, go thicker with rebar. It costs more up front and saves you a cracked slab later.
- Broom finish vs. stamped vs. exposed aggregate: Broom is the least expensive and the best grip in the rain, which matters in a place that gets as much water as this one does. Stamped gives you the look of pavers without the weed lines, at a higher cost and with more slip risk when wet.
- Fiber mesh vs. rebar: Fiber is cheaper and helps with shrinkage cracking. Rebar carries load. For a drive apron that sees a heavy vehicle, rebar is the right call.
- Decorative borders and saw-cut patterns: A scored border or a herringbone cut pattern dresses up a plain slab for a modest addition to the price.
- Sealer or no sealer: A sealer helps resist stains and slows moisture intrusion. It needs reapplication every few years, so factor that into the lifecycle cost.
What Concrete Driveways & Concrete Work costs in Sunset, FL

Plan on $4,500 – $12,000 for a new concrete driveway here. Full replacement of an existing slab lands at $5,000 – $14,000 once you add tear-out and disposal. Sealing an existing slab runs $250 – $700. Those numbers are the range; here’s what actually pushes a job to the top or bottom of it.
- Square footage and thickness: A single-car apron and a long double run are not the same job. Thicker sections for heavy vehicles add cost.
- Existing slab condition: Intact concrete that’s just worn can sometimes be topped or resealed. Cracked, settled or heaved concrete has to come out.
- Site access: A narrow lot where the truck can’t back close means more manual hauling and more labor hours.
- Drainage correction: If the grade has to be reworked to move water away from the house, that’s added excavation.
- Finish selection: Broom is the baseline. Stamped and exposed aggregate add material and labor.
- Permit scope: Work in unincorporated Miami-Dade County goes through the county building department, and the permit pulls in inspection requirements that take time to schedule.
A written estimate from us lists the demo, hauling, base, reinforcement, formwork, pour, finish, joints and cleanup as separate lines. What it does not cover unless we say so: relocating buried utilities, replacing a damaged swale, or decorative stamping that wasn’t in the scope. Upfront pricing, no surprises – the number you see is the number you pay, and the whole job sits under our 730-Day Done Right Promise.
See the difference
Before
After
Before
After
Before
AfterWhat Sunset homes specifically do to this driveway job
Sunset is unincorporated, which means there’s no separate city hall to walk into. Every permit runs through the Miami-Dade County Building Department, and that adds layers of review most homeowners don’t expect. The county’s post-Hurricane Andrew code carries rigorous wind-mitigation requirements and product approvals that are stricter than in a lot of neighboring municipalities, so the paperwork and inspection scheduling take real calendar time. We build that into the schedule instead of pretending it won’t happen.
The housing stock here shapes the work too. Most homes in the 33173 ZIP are 1950s – 1970s concrete block and stucco single-family houses with flat or low-slope roofs, and plenty of them have been expanded or reworked over the decades. That means a new driveway often has to tie in to an older garage apron, a shifted grade or a previous owner’s drainage fix. Our technicians have up to 12 years of experience reading those conditions before the first cut.
The climate drives the rest. Hot, humid summers, heavy afternoon rain and hurricane season mean we schedule pours around the storms, and we build waterproofing and mold prevention into the plan rather than reacting after the fact. As part of a full Driveway & Pavers in Sunset project, the driveway is often the anchor and the walks and pads tie in around it. If you’re also adding living space, homeowners often pair this with ADU Site Prep & Utilities in Sunset since both need the same careful grade and utility coordination, and if the garage door is getting replaced while the slab is new, Door Installation in Sunset is a natural follow-on. We cover the whole of Sunset and the surrounding area.
Serving Sunset, FL – Our Local Coverage Area
We serve Sunset and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Concrete Driveways & Concrete Work in Sunset

Most driveways take 3 – 5 working days of crew time, then a cure period before you park on it. Foot traffic is fine after about 24 hours; heavy vehicles need to wait longer. If the county permit adds inspection scheduling, that stretches the calendar. Call (844) 834-8961 and we’ll give you a realistic start and finish date for your property.
Yes, in most cases. Because Sunset is unincorporated, your permit runs through Miami-Dade County rather than a city building department, and that includes wind-mitigation and inspection requirements. We handle the permit pull and the inspections as part of the job. Call (844) 834-8961 to talk through the scope.
Sometimes, if the existing concrete is sound and the grade is right – a resurface or seal can work. But if the slab is cracked, settled or heaved, it has to come out or the new surface fails with it. We look at it on site and tell you honestly. Call (844) 834-8961 for a free estimate.
New installation runs $4,500 – $12,000 and full replacement runs $5,000 – $14,000, depending on size, thickness, access and finish. Sealing an existing slab is $250 – $700. Call (844) 834-8961 for an exact written quote – estimates are free.
Every concrete job we do is backed by our 730-Day Done Right Promise – if it’s not done right, we make it right. Combined with no-hassle upfront pricing, you know the number before we start and you know the fix is covered. Call (844) 834-8961 to book your estimate.
Ready for a real number on your driveway?
We’ll come out to your Sunset property, measure the run, check the grade and the drainage, and hand you a line-item estimate – free, with no pressure. Calls are answered by a live person 24/7, and technicians arrive in uniform and background-checked. Whether it’s a fresh pour or a full replacement, that estimate is the first step. Call (844) 834-8961 today and let’s put it on the calendar.
Written by the team at Groundwork Construction Co.












