







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Paver Driveways in Richmond Heights, FL: What the Job Actually Takes
Paver driveway installation in Richmond Heights typically runs $7,000 to $18,000 for a standard two-car drive, and most jobs take three to six working days from demo to sealer. That number covers excavation, a compacted base, filter fabric, sand setting bed, pavers, edge restraint, and joint sand. A paver driveway is the last hardscape most Richmond Heights homes will ever need, which is why the base prep matters more than the pavers themselves. Call (844) 834-8961 for a free on-site estimate.
How a paver drive gets built, day by day

Few contractors will walk you through the sequence, so here’s what actually happens on your property.
Day 1: Layout and demolition
We mark the new drive footprint with paint and string lines, then cut out the old surface. If there’s existing concrete or asphalt, that goes into a roll-off dumpster along with the subgrade soil we displace. On a Richmond Heights CBS home, the drive often butts right up to the carport slab, so we take extra care at that joint. Final decisions on this day: exact paver pattern direction and where the downspout discharges will land.
Days 1 – 2: Excavation and base
We excavate to a depth that accommodates the paving stone plus a 6- to 8-inch compacted aggregate base (Miami-Dade limerock over the local sandy subgrade holds up better than crushed concrete). The base goes in 2- to 3-inch lifts and gets plate-compacted after each. Skimp on this stage and the drive will rut in two summers. This is the single biggest cost driver and the one stage where a low bid almost always shows.
Day 2: Grading and inspection
Before any paver goes down, we set final grade and verify slope away from the house, usually 1.5% to 2% fall toward the street or a swale. Because Richmond Heights sits in the Miami-Dade High Velocity Hurricane Zone, larger paving jobs sometimes trigger a county review of runoff and right-of-way work; we confirm that on the permit call before we order material. You see the grade with a laser level or you don’t accept it. That’s a homeowner checkpoint, not a contractor courtesy.
Days 3 – 5: Laying pavers
Filter fabric, then a 1-inch sand setting bed, then the stones. A crew sets 400 to 800 square feet a day depending on pattern complexity. Running bond and herringbone lay faster than fan or mosaic patterns. We cut edges with a wet saw, install the plastic edge restraint, and finish with polymeric joint sand. Decisions you make here: border band color and whether the driveway apron gets a contrasting paver.
Day 6: Cleanup and sealer
We sweep, reset any joint sand, rinse the drive, and apply sealer after the pavers dry, usually within 24 to 48 hours. We walk the finished drive with you, show you the slope, and hand over a small bag of spare pavers for future repairs. Everything above is covered by our 730-Day Done Right Promise.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Paver choices and what each one commits you to
The paver you pick sets the color palette for the house and the maintenance for the next twenty years. Here’s the honest trade-off of each major option.
- Concrete pavers (interlocking): $7,000 to $18,000 range for the full drive. Most durable, longest life, best color-fastness. Molded from sand, cement, and pigment, then cured. The trade-off: fewer color-matching choices than clay and slightly cooler underfoot than asphalt, but your best value in Richmond Heights.
- Clay or brick pavers: $9,000 to $22,000. Real fired brick, richer color, ages beautifully. The trade-off: higher cost, softer underfoot chipping if you drive a heavy truck over a bad base, and more sensitive to freeze cycles (rare here, but still). A common choice for ranch homes wanting a period-appropriate look.
- Permeable pavers (with open joints): $10,000 to $20,000. Water drains through the joints to the base. The trade-off: installation requires an engineered open-graded base and higher material cost, but it reduces runoff and is worth considering if your drive holds water during May-October storms.
- Tumbled / antiqued finish: adds $500 to $1,500. Slightly irregular edges, classic appearance. The trade-off: catches more sand and grit in the joints, so it needs sweeping.
- Border bands and pattern upgrades: a contrasting soldier course border adds $400 to $1,200. Herringbone pattern adds 10-15% to labor over running bond. Worth it for curb appeal, but not for everyone.
We primarily install pavers from Belgard, which makes both old-world and modern profiles and carries a strong reputation for color consistency across the run.
What Paver Driveways cost in Richmond Heights, FL

Expect $7,000 to $18,000 for a complete paver driveway on a typical Richmond Heights lot. That’s per the ranges we publish across the site, and the estimate you get in person should land inside it unless something unusual turns up under the old drive.
Five factors push the number toward the high or low end:
- Square footage: a tight one-car drive near the low end, a wide drive with a turnaround or carport apron toward the high end.
- How much stuff is under the current drive: an old concrete slab means demolition, haul-off, and possibly a thicker base. A bare dirt drive runs lower.
- Base thickness and subgrade: sandy South Florida soil may need more limerock to hit the compacted spec. This is not a place to cut corners.
- Paver grade and pattern: tumbled clay with a border in herringbone costs meaningfully more than standard running-bond concrete pavers.
- Permit and drainage scope: if the job touches a swale or a right-of-way, the county process adds time and expense.
Every written estimate includes demolition, disposal, base, filter fabric, pavers, edge restraint, joint sand, and cleanup. What it typically excludes: landscape repair after heavy equipment, drainage lines or French drains unless quoted, and sealing beyond the first application.
See the difference
Before
After
Before
After
Before
AfterWhat Richmond Heights does to a paver driveway job
Most homes in this ZIP (33176) are post-WWII CBS ranches and block-and-stucco homes built between the 1950s and 1970s, with driveways that are wide, short, and often abut a carport or detached rear garage. When we tear out an original drive here, we almost always find the original thin slab with no expansion joints, cracking along the carport threshold, and roots from a mature oak reaching into the subgrade. Because those homes are aging, we’re also working on drives that have been patched several times, so the demo stage runs longer.
The other factor unique to Richmond Heights is the Miami-Dade High Velocity Hurricane Zone. Every product in the build has to meet wind-load and product-approval rules, and we’re careful that paver edge restraints and the base spec withstand the wind-driven rain of a May-to-November hurricane season. Permits for paving on residential property usually go through Miami-Dade County; we pull them before the job and make sure the base and grade pass inspection before any paver goes down. We work this narrow section of south Dade regularly, so we know the county process and the inspectors, and we’re usually within 15 to 20 minutes of most Richmond Heights addresses. If your project widens beyond the drive, our Driveway & Pavers in Richmond Heights page covers the full scope.
Serving Richmond Heights, FL – Our Local Coverage Area
We serve Richmond Heights and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked questions

Most driveways finish in three to six working days, weather permitting. Rain in May through October can add one or two days for base drying, and we don’t lay pavers on a wet bed.
Usually yes, and we pull it for you. Miami-Dade County issues the permit, and any job touching a swale, right-of-way, or drainage line gets a closer look. We handle the paperwork and inspections.
You can, but we don’t recommend it. Reasons: the old slab is usually at grade or above, so a paver over it ends above the sidewalk and traps water. Removing and replacing the base gives you a driveway that will hold up, and doing it once costs less than doing it twice.
$7,000 to $18,000 for most standard drives. Size, base depth, existing slab, pattern, and permit scope push it to the ends. Call (844) 834-8961 for an exact quote; estimates are free.
Our 730-Day Done Right Promise covers installation for two years. If the base settles or a paver shifts, we come back and fix it. We also leave you spare pavers so a future repair can match.
Get a free estimate for your Richmond Heights paver driveway
Call (844) 834-8961 for a free, no-pressure estimate at your Richmond Heights home. We’ll measure the drive, talk through base condition, paver options, and permit scope, and hand you a written fixed-price quote. No change orders, no surprises. We answer the phone around the clock, and quotes are good for 30 days. If your project grows into more than a driveway, our Driveway & Pavers team can handle it. Homeowners who want to upgrade their entry often paired this with Door Installation in Richmond Heights.
You can also see all the neighborhoods we cover on our Richmond Heights service-area page. If you’re planning a kitchen refresh at the same time, our Cabinets & Countertops in Richmond Heights page has you covered.
Written by the team at Groundwork Construction Co.












