







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in Fountainebleau, FL: What It Takes
A standard concrete driveway in Fountainebleau runs $4,500 to $12,000, and a full replacement typically lands between $5,000 and $14,000. Most single-drive pours here are a 3 to 5 day job once the subgrade is ready: demo and haul-off day one, form and rebar the next, pour and finish, then cure before you park on it. Call (844) 834-8961 for a free on-site estimate and a written line-item scope.
How We Pour a Driveway in Fountainebleau, Step by Step

Concrete work rewards patience and punishes shortcuts, and a Fountainebleau driveway that has to survive a South Florida wet season is no place to cut corners. Here’s the actual sequence, with the decisions you’ll be making along the way.
Stage 1: On-site assessment and layout (day 1). We walk the drive, check the existing slab for cracks and settlement, and confirm the width and slope you need. At this stage you decide the overall footprint: a straight single-car run, a widened apron for a second vehicle, or a turn-around that clears a detached workshop or garage. Getting the layout right here saves a re-pour later.
Stage 2: Demolition and haul-off (day 1-2). The old slab, or the grass and topsoil, comes out, and every bit of it leaves the property. Fountainebleau lots sit close to neighboring drives and walls, so we protect the edges and keep the spoils contained. Hauling is included in the estimate, not tacked on after.
Stage 3: Subgrade and base prep (day 2-3). We grade the base, compact it, and check the slope for drainage. This is where most cheap jobs fail: a thin base or a flat pour holds water and cracks within a couple of seasons. You decide whether you want a thicker slab for a heavier vehicle or a small load-bearing pad for a workshop approach.
Stage 4: Forming, reinforcement, and pour (day 3-4). Forms go in, rebar or mesh gets tied, and the concrete is placed and finished. Control joints get cut so the slab cracks where we want it to, not across the middle. Finish choice (broom, exposed aggregate, or a simple float) is yours to make, and we set it before the truck arrives.
Stage 5: Cure and final walk (day 5 onward). The slab cures, joints get sealed, and we walk the finished drive with you. Foot traffic resumes in about 24 to 48 hours, vehicles in roughly a week depending on weather. This is the moment you inspect the slope, the edges, and the finish, and the point where our 730-Day Done Right Promise starts.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Concrete Options You’ll Weigh Before We Pour
Most of the choices on a concrete driveway come down to how you’ll use the surface and how much finish matters to you. These are the ones that actually change the price and the life of the job.
- Standard 3,000-4,000 PSI slab: the workhorse for a residential drive. Holds up to normal cars and light trucks, pours clean, and keeps the budget in range. Fine for most Fountainebleau homes unless you’re parking something heavy on it.
- Thicker reinforced slab: more concrete and more rebar for heavier loads, like a work truck or the approach to a detached workshop. Costs more up front and lasts longer under weight. Worth it if you’ll be parking equipment, not just a sedan.
- Broom finish: textured for grip in the rain, the standard choice for a wet-climate driveway, and the most economical finish. Slight texture, no slip risk when the summer storms roll through.
- Exposed aggregate: a rougher, decorative surface that hides tire marks and holds traction. Priced above broom and slower to place, but it looks good and wears hard.
- Joint sealing: the optional add-on that keeps water out of the control joints. We use a product like Sakrete’s sealer line for a clean, repeatable finish. It’s a small line item that extends the life of the pour.
If your project grows into a wider outdoor scope, this work is often part of a full Driveway & Pavers in Fountainebleau plan, and we can scope the concrete portion to sit alongside it.
What Concrete Driveways & Concrete Work Costs in Fountainebleau, FL

Expect $4,500 to $12,000 for a new concrete driveway, $5,000 to $14,000 for a full replacement, and $250 to $700 for joint sealing. The spread inside those ranges comes down to a handful of variables, and it’s worth knowing which ones you control.
- Size and thickness: a single-car apron and a wide turn-around are different jobs. Square footage and slab thickness are the two biggest drivers.
- Existing condition: a clean grass strip is cheaper to prep than an old cracked slab that needs full demo and haul-off.
- Base and grading: a lot that needs significant regrading or a deeper compacted base adds cost, but skipping it is what causes the cracks.
- Finish and reinforcement: broom and mesh sit at the low end; exposed aggregate and a thicker reinforced slab push toward the top.
- Permits and inspections: Miami-Dade’s process adds time and a fee, and we pull the permits and schedule the inspections as part of the job.
A written estimate from us spells out excavation, base, reinforcement, concrete, finish, joint cutting, sealing if you want it, haul-off, permits, and inspections. It won’t include landscaping repair around the edges or drainage additions you add later, and we’ll tell you that up front so there are no surprises.
See the difference
Before
After
Before
After
Before
AfterWhat Fountainebleau Homes Specifically Do to This Job
Fountainebleau is a built-out west Miami-Dade suburb, and that shapes concrete work here more than most homeowners expect. The housing stock is largely 1960s to 1980s single-family ranches and low-rise buildings, so we’re almost always replacing an aging slab or working around mature landscaping rather than pouring on open ground. On the Palmetto Expressway side and along the Flagler corridor, tighter lots mean careful staging and protected edges.
Every pour runs through Miami-Dade County’s high-velocity hurricane zone permitting and product-approval (NOA) regime, which affects scheduling and material sign-off in a way contractors from other metros don’t plan for. Our subtropical climate adds the rest: intense UV, year-round humidity, and a May to November storm season that punish a poorly drained slab. We grade away from the structure and cut joints correctly so summer downpours don’t pool and crack the surface. For storm-hardened upgrades, homeowners often pair this with Door Installation in Fountainebleau.
Serving Fountainebleau, FL – Our Local Coverage Area
We serve Fountainebleau and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Concrete Driveways & Concrete Work in Fountainebleau

A typical single driveway takes 3 to 5 working days from demo to final walk, plus roughly a week of curing before you drive on it. Full replacements with heavy demo or regrading can run longer. Call (844) 834-8961 for a schedule based on your actual site.
Yes, a concrete driveway or structural concrete pad in Fountainebleau generally requires a Miami-Dade County permit and inspection. We pull the permits and schedule the inspections as part of the job, so the driveway you get is code-compliant and properly signed off.
In most cases yes. A driveway pour stays on the surface and doesn’t touch underground plumbing or structure, and we protect existing landscaping at the edges. If the scope grows into a larger build-out, homeowners often pair this with ADU Site Prep & Utilities in Fountainebleau, which is where utilities do come into play.
A full replacement runs $5,000 to $14,000, and a new pour from scratch runs $4,500 to $12,000. Size, base condition, and finish move the number. Call (844) 834-8961 for an exact quote, and the estimate is free.
Every concrete job is covered by our 730-Day Done Right Promise. If it isn’t done right, we make it right. That’s the standard on the whole driveway & pavers service. We also guarantee the price you see is the price you pay, with no change orders for the scope we quoted.
Get a Free Concrete Estimate in Fountainebleau
If you’re weighing a new driveway, a replacement slab, or a concrete pad for a workshop, start with a free on-site estimate. We’ll look at your Fountainebleau property, walk you through the options and the real cost, and put it in writing. Call (844) 834-8961 – a live person answers 24/7 – and we’ll get your estimate on the calendar.
Written by the team at Groundwork Construction Co.












