







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Fountainebleau, FL: What It Takes and What It Costs
Door installation in Fountainebleau typically runs $650 to $3,800 per door for an exterior unit rated for Miami-Dade’s High-Velocity Hurricane Zone, with most single-door jobs finishing in one to two days once the NOA-approved product is on site. The scope covers removing the old slab or pre-hung unit, squaring and shimming the rough opening, sealing and anchoring to the county’s wind-load spec, and passing the framing and final inspections. Call (844) 834-8961 for a free on-site estimate before you buy a door.
How our door installation process actually runs, stage by stage

Most homeowners have never seen a wind-rated door go in, so here’s the real sequence. No two Fountainebleau jobs are identical, but the rhythm holds.
Stage 1 – On-site measure and product approval check (day 1, 45 to 90 minutes)
We measure the rough opening, check wall thickness and stucco depth, and confirm whether the existing header is sound. Then we match your opening to a product that carries a current Miami-Dade Notice of Acceptance (NOA) at the design pressure your address requires. This is the decision point where you pick material, glass, and hardware. Getting the NOA right here is what keeps you from failing inspection later.
Stage 2 – Order and permit (2 to 6 weeks, mostly lead time)
Impact-rated and NOA-listed doors aren’t stock items at most suppliers, so order lead times run two to six weeks depending on the manufacturer and finish. We pull the permit during this window. You sign off on the final spec sheet before the order locks, and that’s also when you confirm hardware and any sidelight configuration.
Stage 3 – Demo and rough opening prep (day one of install, 2 to 4 hours)
We cut out the old unit, inspect the framing and any rot behind the stucco, and square the opening. On 1960s and 1970s ranch homes in Fountainebleau, this stage often reveals water damage at the sill or a header that needs sistering. We photograph what we find and tell you the cost before we add it, in writing.
Stage 4 – Set, anchor, seal, and flash (day one to two, 3 to 5 hours)
The new door gets set plumb, shimmed, and anchored to the county’s fastener schedule, then flashed and sealed with high-grade polyurethane or silicone. Wind-driven rain is the enemy here, so the flashing detail matters more than the door you chose.
Stage 5 – Hardware, adjustment, and final inspection (day two, 1 to 2 hours)
We hang the slab, set the lockset and closer, adjust the threshold and weather stripping, and walk it with you. Then the county inspector signs off. Most Fountainebleau door installations wrap in one to two working days on site; the lead time before that is the long part.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll choose between for a Fountainebleau door
- Fiberglass vs. steel vs. wood slab. Fiberglass holds finish longest in South Florida sun and resists humidity swell, at the higher end. Steel is cheaper but dents and rusts at any scratch. Wood looks best and needs refinishing every few years in Fountainebleau’s humidity.
- Impact glass vs. solid or decorative. Impact glazing adds cost but satisfies HVHZ requirements without shutters. Solid doors skip the glass question entirely and often suit a service or side entry.
- Pre-hung vs. slab. Pre-hung is faster and more reliable for a sound opening; a slab replacement only makes sense when the existing frame is solid and square.
- Hurricane-rated hardware. Multi-point locks and reinforced hinges run more but meet the wind-load spec and keep the door from racking under pressure.
- Screen or storm door add-ons. A storm door on top of the primary entry adds a UV barrier, though it must be rated and anchored correctly to avoid inspection trouble.
What door installation costs in Fountainebleau, FL?

Expect $650 to $3,800 per door installed, with the range driven by material and wind rating. A basic interior door replaced sits at the low end; a full impact-rated exterior entry with sidelights and multi-point hardware lands near the top.
- Door type and material: a hollow-core interior door vs. an NOA-listed impact exterior entry accounts for most of the spread.
- Existing opening condition: rot, out-of-square framing, or a failing header adds labor and material.
- Wind rating and glass: impact glazing and HVHZ-rated assemblies cost more than standard units.
- Permit scope: an exterior door in the HVHZ requires a permit and inspection, which adds a few hundred dollars and time.
- Hardware and finishing: premium locksets, closer units, and paint or stain add to the total.
A written estimate should spell out the door model, NOA number, fasteners, flashing, permit fees, and cleanup. What typically sits outside the estimate: unforeseen rot repair or framing, and any custom millwork.
See the difference
Before
After
Before
After
Before
AfterWhat Fountainebleau homes specifically do to this job
Fountainebleau is built out, not being built, and that shapes every door job here. Most of the housing stock is 1960s-1980s single-family ranch homes and low-rise multifamily, with a lot of original single-glazed openings and stucco walls that have taken 40 to 60 years of subtropical sun. That means we almost always work around hardened stucco, aging framing, and headers that need attention. And because every exterior door in the High-Velocity Hurricane Zone must carry a Miami-Dade NOA approval, the paperwork and inspection add scheduling most contractors elsewhere never face. Drive the corridor along the Palmetto Expressway and Flagler and you’ll see the same pattern: retrofit, build-out, and code-driven upgrade in an already-built environment. Homeowners here often pair a new entry with a wider opening project – part of a full Windows & Doors in Fountainebleau scope – and sometimes a kitchen refresh using Cabinets & Countertops in Fountainebleau while trades are already on site.
Serving Fountainebleau, FL – Our Local Coverage Area
We serve Fountainebleau and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Door Installation in Fountainebleau

On-site install time is usually one to two working days per exterior door; the lead time for an NOA-rated unit and the permit runs two to six weeks before that. Call (844) 834-8961 for a schedule that fits your address.
Yes. Exterior door replacement in Fountainebleau falls under Miami-Dade’s High-Velocity Hurricane Zone rules and requires a permit plus inspection. Interior door swaps generally do not. We pull the permit and manage the inspection.
Usually yes, when the header and framing are sound. We only open the wall where rot or a failing header turns up; that’s the one variable we won’t know until demo day. We tell you before any extra work starts, in a written line-item.
Plan on $650 to $3,800 per door installed, with impact-rated exterior entries at the top. Call (844) 834-8961 for an exact quote – estimates are free.
Every door installation is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. Manufacturer warranty on the door itself is separate and we hand you the paperwork.
Get a free door installation estimate in Fountainebleau
Call (844) 834-8961 and we’ll set up a free on-site estimate for your door installation in Fountainebleau. You’ll get an upfront written quote with the door model, NOA number, permit, and labor itemized, so the number you see is the number you pay. As part of our wider Windows & Doors work, we cover Fountainebleau and nearby areas. Planning a bigger project? Homeowners often pair a new door with a Garage Conversion ADU in Fountainebleau that needs matching impact openings. Calls are answered by a live person, 24/7.
Written by the team at Groundwork Construction Co.












